Fusion Maker/Edge/Pro
17000 (Maker Edge Pro) - Replacing the Control Panel
Introduction In this article we will walk you through replacing the control panel on the Epilog Fusion Edge laser system. Tools Required Replacing the Control Panel. Turn off and unplug the machine. Remove Panel Using a 5/32″ Hex Key, remove the 8 ...
17000 (Maker Edge Pro) - X-Axis Belt Tensioning Guide
Instructions on tensioning the X-Axis belt on a 17000 Edge, Maker, Pro, or 16000 Pro 48 200 Watt. Overview This document and video provide instructions on utilizing the X-Axis belt tensioning tool. The tool assesses the belt's tightness, allowing us ...
17000 (Maker Edge Pro) - Updating the Firmware
Firmware update procedure for the Fusion Maker, Edge, Pro, and Galvo. Find the newest version of the firmware for your engraver by clicking HERE. Overview In firmware version 1.0.9.0, the update process has been streamlined. For systems operating on ...
17000 (Maker Edge Pro) - CO2 Laser No Outuput Checklist
This document is designed to help determine if you need to replace your laser tube. Overview These items should be checked before replacing a CO2 laser tube with no output. If the laser has been inactive for more than one (1) month, follow the ...
17000 (Maker Edge Pro) - CO2 Laser Low Output Checklist
Overview Having to continually reduce speed and increase power can indicate low output from the laser. This document will help identify a low output laser tube on a 17000 Maker, Edge, or Pro machine. There is a PDF version of this document on the ...
Epilog - 220VAC Power Connections: Core End Type and Photo
Epilog's laser systems use auto-switching power supplies accommodating 110 to 240 volts at 50-60Hz. We recommend a dedicated 15A breaker regardless of voltage. If you are going to be running your laser on a 220V and are located in the United States, ...
17000 (Maker Edge Pro) - CO2 Laser Alignment
Introduction In this article we’ll walk you through aligning the laser on the Epilog Fusion Edge & Fusion Pro. During this procedure, all persons present in the room must be equipped with eye protection, such as safety glasses, eyeglasses or goggles. ...