Epilog - Mini, Helix Laser Alignment

Epilog - Mini, Helix Laser Alignment

CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally.

Download the Attached PDF for Detailed Instructions. 

Complete this procedure if any of the following behaviors are observed:
  1. Laser power appears weak in certain areas of the table, especially when moving from left to right in the engraver.
  2. The engraver cannot effectively cut through materials at or around the recommended settings.
  3.  Optics in the lens assembly fail prematurely.
  4.  If the engraver has been moved to a new location

Or if any of these components have been replaced:

  1.  Laser tube
  2. Mirror #1, #2, or #3
  3. X-axis assembly
  4. Red dot diode



    • Related Articles

    • 17000 (Maker Edge Pro) - CO2 Laser Alignment

      Introduction In this article we’ll walk you through aligning the laser on the Epilog Fusion Edge & Fusion Pro. During this procedure, all persons present in the room must be equipped with eye protection, such as safety glasses, eyeglasses or goggles. ...

    • Epilog - Zing 16 Laser Alignment

      CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...

    • Epilog - Zing 24 Laser Alignment

      CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...

    • 14000 - Fusion M2 Laser Alignment

      Introduction In this article we’ll walk through aligning the Epilog Fusion M2’s laser. During this procedure, all persons present in the room must be equipped with eye protection, such as safety glasses, eyeglasses or goggles. Do not place any part ...

    • Epiog - 36 EXT Laser Alignment

      CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...