Roland - Nozzle Mask Function for SG2 and VG2

Roland - Nozzle Mask Function for SG2 and VG2


To address dot drop-out or displacement issues even after thorough cleaning, consider employing a technique called "nozzle masking." This involves restricting the use of specific print heads, which causes discharge problems and mitigates the impact of these issues. While this method may reduce printing speed, it offers a way to improve print quality. Begin by printing a test pattern, analyze the results to identify problematic nozzle groups, and then utilize VersaWorks to designate which nozzle group to use for printing.
​



    • Related Articles

    • Fixing Incorrect Media Width Reading on Roland TruVis Printers

      Applies to: Roland SG, VG, SG2, SG3, VG2, VG3 models Issue When using shorter rolls of media, the printer may incorrectly read the media width as wider than it actually is. This happens when the pinch roller with the blue mark is positioned outside ...

    • Roland DGA - Replacing a Captop SG/VG

      Introduction: Ensuring consistent and high-quality prints is essential for any printing operation. One crucial component in achieving this goal is the cap top, which plays a vital role in preventing ink clogs and maintaining the integrity of your ...

    • Roland DGA - VersaWorks 6 Job Assistant

      VersaWorks 6 is a powerful RIP Software that’s used to drive Roland DG’s most powerful equipment and inkjet technologies. Since its inception, the program has routinely been updated with improvements, new features, and added functionality. Recently, ...

    • Roland DG Download Center

      The Roland DG Download Center is your central hub for accessing essential software, firmware updates, drivers, and product manuals for Roland DG equipment. Whether you're setting up a new device or updating existing hardware, this portal provides the ...

    • Roland DGA - Using Rotary Mode to Optimize Printing with LEF Series Flatbeds and RotaPrint

      If you print on cylindrical objects with an LEF series flatbed and RotaPrint, you’ll want to take full advantage of the Rotary Mode. The Rotary Mode firmware update was released a couple of years ago, and we want to make sure LEF owners are using ...