16000 (Fusion Pro 32 & 48) - Leveling the Table

16000 (Fusion Pro 32 & 48) - Leveling the Table

Download the Attached Document for Detailed Instructions:

Table level should be checked periodically to ensure that all areas of the table are the same distance from the focusing lens. If all areas of the table are not the same distance from the focusing lens, loss of laser power and inconsistent engraving and cutting marks can occur.

Complete this procedure if any of the following behaviors are observed:

  1. Laser power appears weak in certain areas of the table.
  2. The engraver cannot cut through materials at or around the recommended settings in certain areas of the table.
  3. If the engraver has been moved to a new location.


    • Related Articles

    • 17000 (Maker Edge Pro) - CO2 Laser Alignment

      Introduction In this article we’ll walk you through aligning the laser on the Epilog Fusion Edge & Fusion Pro. During this procedure, all persons present in the room must be equipped with eye protection, such as safety glasses, eyeglasses or goggles. ...

    • Preventative Maintenance Schedule – Epilog Fusion Edge & Pro 17000 Series

      This guide outlines the recommended preventative maintenance (PM) schedule for the Epilog Fusion Edge & Pro 17000 Series laser systems. Performing these tasks regularly ensures optimal performance, reduces fire hazards, and helps extend the life of ...

    • Epilog - Fusion M2 Focus, Home, and Table Calibration

      Download the Attachment for Detailed Instructions This document provides step-by-step instructions for calibrating the focus gauge, auto-focus, table home, x-y home, squaring of vector grid, and vector grid home for the Fusion M2 model Epilog laser ...

    • 13000/14000 - Fusion M2 Adjusting the Table Level

      Introduction This procedure will guide you through the process of properly checking and adjusting the table level on the Epilog Fusion. This will ensure proper focus on every point of the engraving area. When to Adjust the Table Level Uneven power in ...

    • 17000 (Maker Edge Pro) - Testing Motors During Startup

      This article outlines the steps for testing the motors during the startup sequence of the Epilog Fusion 17000 (Maker Edge Pro) Laser system. Pre-Startup Manual Positioning Before powering on the machine, manually move the components to the center of ...