Epilog - Printing to the Epilog Dashboard from Adobe Illustrator

Epilog - Printing to the Epilog Dashboard from Adobe Illustrator


    • Related Articles

    • Epilog - Vector Lines are Not Being Spilt by The Dashboard

      1. Ensure vector line weights are set properly: Hairline - Corel Draw .001 - Adobe Illustrator 2. Epilog Dashboard Settings May Not Be Configured Properly: Open the Epilog Dashboard Click the settings gear In the upper right-hand corner. Navigate to ...

    • Epilog - Adobe Illustrator Images and Vector Cut Lines Ignored

      Issue: Adobe Illustrator: Certain Images wipe out vector hairlines when printed to the epilog driver. The vector lines are treated as engravings when they make it into the epilog print driver. Something in the image source file seems to cause the ...

    • Epilog Fusion Maker and Edge 12 – Pre-Install Checklist

      Before scheduling installation or training for your Epilog Fusion Maker 12 or Epilog Fusion Edger 12 laser system, please verify that all utilities, workstation setup, and site conditions meet the requirements listed below. ✅ Power Requirements ✔️ ...

    • Epilog Fusion Maker 36 & Edge 36 – Pre-Install Checklist

      Before scheduling installation or training for your Epilog Fusion Maker 36 or Epilog Fusion Edge 36 laser system, please verify that all utilities, workstation setup, and site conditions meet the requirements listed below. ✅ Power Requirements Fusion ...

    • Epilog Fusion Maker and Edge 24 – Pre-Install Checklist

      ✅ Power Requirements ✔️ Voltage: 120V AC, 60 Hz ✔️ Dedicated 15A grounded outlet ✔️ Outlet should be within 6 ft (1.83 m) of the machine ✔️ Do not use extension cords or power strips—plug directly into wall outlet ✅ Workstation & Software ...