Mini / Helix
Epilog - Adjusting Table Level for the Mini and Helix
Ensuring a perfectly level table is not just a step, but a crucial prerequisite for any cutting or engraving project. In this guide, we'll walk you through the process of checking your table level and making adjustments as necessary. Checking the ...
Epilog - Cleaning the X-Axis Linear Encoder
Issue: If you are seeing wavy engraving, or the engraving seems to be drifting across the page, you probably have a dirty linear encoder. Cleaning is a quick process that we will explain below. Solution: Before you begin the steps for cleaning your ...
Epilog Helix - System LCD error = Sys PleaseR or Please Reboot.
It could be a controller or laser tube. Turn off the machine and unplug the ethernet connector on the laser tube. Then reboot. If the error still exists with the tube ethernet disconnected, the controller needs to be replaced. Turn off machine and ...
Epilog - Mini, Helix Laser Alignment
CO2 laser alignment should be checked periodically to ensure the engraver is performing optimally. Download the Attached PDF for Detailed Instructions. Complete this procedure if any of the following behaviors are observed: Laser power appears weak ...